Arris Touchstone DG1670 User Manual page 20

Getting
Safety Started
Step 1
Step 3
Step 5
Ethernet
Installation Configuration
1 Position the mounting bracket on the surface where you intend to mount
the Data Gateway and mark the two holes with a pencil.
2 Drill holes through the marked locations for the mounting screws.
3 If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8" (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
4 Slip both mounting slots in the back of the mounting bracket over the
screws, then slide the bracket down until the narrow end of the keyhole slot
Step 2
contacts the screw shaft.
5 Hang the Data Gateway on the wall by inserting the six tabs on the mount-
ing bracket into the six slots in the back of the Data Gateway and sliding the
Data Gateway down until it drops in place on the bracket.
6 Proceed to
Desktop mounting instructions
1 Position the Data Gateway so that:
Step 4
• it stands vertically on its base. (Do not lay it flat on its side.)
• air flows freely around it
• the back faces the nearest wall
• it will not fall to the floor if bumped or moved
• the ventilation holes on the sides of the unit are not blocked.
2 Proceed to
Touchstone DG1670 Data Gateway User's Guide
Usage Troubleshooting
Connecting the Data Gateway.
Connecting the Data Gateway.
Glossary
20