Table of Contents
Advertisement
PREPARATION
Check this list to ensure that all appropriate parts
are packed with your system. See Page 4 for a
complete parts breakdown.
Determine approximate location for installation of
system: Filtration unit, saddle tapping valve and
reservoir.
LOCATION OF RESERVOIR
The reservoir is placed within the unit. Tubing
length between components should be kept to a
minimum, avoiding sharp bends or kinks.
Figure 1 Component and Interconnection Locator
031666-009 Rev C 2000
INSTALLATION STEPS
Filtration Unit may be installed in any convenient
location. The unit must be within 15 feet of the
source water supply and other Point-Of-Use
systems if applicable.
Do not place unit where it will be exposed to
freezing and/or direct sunlight.
Page 2 of 11
LOCATION OF FILTRATION UNIT
Advertisement
Table of Contents
