Table of Contents
Advertisement
Symptom
No water
Not enough water
Water has an offensive taste
and/or odor
Leak at fitting
Leak at filter housing
Leak at saddle tapping valve
* Always check there is adequate lubricant (P/N 030429-001) on O-rings before installation.
031666-009 Rev C 2000
SYSTEM TROUBLE SHOOTING GUIDE
FILTRATION SYSTEM
Probable Cause
Water supply is turned OFF
Water supply is blocked
Clogged filter cartridges are
restricting water flow
Filters depleted
Tubing not pushed completely
into fitting
Defective tube
Worn or damaged O-ring
O-ring has not seated
O-ring has nick or scratches
Loose clamp
Tubing deformed
Page 7 of 11
Solution
Turn water ON
Clear restriction, rotate valve
handle on tap water feed valve
Replace carbon cartridges
Replace
filters,
clean
sanitize system
Push tube into fitting past O-ring
seal
Cut damaged area off of tube or
replace tube
Replace O-ring*
Lube and Reseat O-ring*
Replace O-ring*
Tighten clamp screws, do not
crush source water tubing
Cut damaged area off of tube or
replace tube and sleeve
and
Advertisement
Table of Contents
