HIKVISION DS-6101DI Series User Manual page 25

User Manual of DS‐6101DI Decoder
Window division configuration
By right clicking the decoder channel, user can
select the screen division mode.
The BNC output can be selected to 1, 2 or
4-division display modes.
After configuration of the window division, if it
has reached the limit of decoding source, then the
system will display the warning message of
Decoder channel not available! when the user
continues to enable the decode output channel.
After having enabled the decoding output and
configured the display mode, user can change
the size and position of the display window.
Click the mouse and hold on the title below the
window to change its position. By dragging a
border of the decoder, user can change the size
of the window. You can also use the layout
toolbar to adjust the size and position.
Refer to the following table for the description of layout toolbar:
Button Description
Align left
Align top
Vertical center
Equal horizontal interval
Equal width
Equal size
Button
24
Description
Flush right
Flush bottom
Horizontal center
Equal vertical interval
Equal height