Honda XR250 Tornado Owner's Manual page 148

Owner´s Manual
Installation Notes
• Reverse the removal procedure.
• Insert the front axle shaft through the wheel hub and
left fork leg.
Make sure that the tang (5) on the speedometer gearbox
is located behind the tang (6) on the right fork leg.
• Tighten the front axle shaft to the specified torque:
59 N·m (6.0 kgf·m, 44 lbf·ft)
• Tighten the upper axle holder nuts to the specified
torque first, then tighten the lower axle holder nuts
to same torque.
Axle holder nut torque:
12 N·m (1.2 kgf·m, 9 lbf·ft)
• After installing the wheel, apply the brake several
times and then check if the wheel rotates freely.
Recheck the wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for installation, see
your Honda dealer as soon as possible to verify proper
assembly. Improper assembly may lead to loss of
braking capacity.
(6)
(5) Tang (Speedometer
gear box)
(6) Tang (Right fork leg)
(5)
67