Dbs Receiver Multi-Brand Remote Control - JVC HR-S4600U Instructions Manual

56
EN
CABLE/DBS
1
4
7
1
STOP
DBS BRAND NAME
JVC (DISH Network)
ECHOSTAR (DISH Network)
PRIMESTAR
SONY (DSS)
RCA (DSS)
POWER
2 3
2
NUMBER
5 6
8 9
0
4
TV CH+/–
BRAND CODE
51
51
50
41
40
SPECIAL FEATURES (cont.)
DBS Receiver Multi-Brand
Remote Control
The VCR's remote control can control functions on the brands of
DBS (Direct Broadcast Satellite) receivers listed below.
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receiver's remote
control.
ENTER DBS RECEIVER
BRAND
2
While holding down CABLE/DBS on the VCR's remote
control, press MBR SET and use the NUMBER keys to
enter the DBS receiver brand number from the chart in
the left column and then press STOP.
Follow the example shown below.
The DBS receiver's power should go off. If it does, try
other operations (
Once you have set the remote control to operate the
DBS receiver, you don't have to repeat this step until
you replace the remote control's batteries.
OPERATE DBS RECEIVER
3
First, while holding down CABLE/DBS, press the
corresponding button: POWER, TV CH +/–, NUMBER
keys.
Depending on the DBS receiver you may have to
press ENTER after having pressed the NUMBER keys.
To change the DBS receiver's channel, press TV CH
+/– or the NUMBER keys. (The CH +/– button can be
used to change the VCR's channel only.)
NOTES:
Depending on the type of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
It's not possible to operate a DBS receiver that is not equipped
with a remote control sensor.
Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
It's not possible to set the remote control for both your DBS
receiver and a cable box at the same time. You can only set
the remote control to operate one of these units at a time.
(Ex.) To set remote control to JVC 51:
CABLE/ MBR SET
DBS
A/B
5
Hold
Press in succession
down
step 3).
STOP
1 Release