Dbs Receiver Multi-Brand Remote Control - JVC Model HR-DVS1U Instructions Manual

68
EN
VCR/TV/CABLE/DBS
NUMBER
1
STOP
TV CH –
DBS BRAND NAME
JVC (DISH Network)
ECHOSTAR (DISH Network)
PRIMESTAR
SONY (DSS)
RCA (DSS)
(Ex.) To set remote control to JVC 51:
POWER
5
Hold down Press in succession
POWER
T W
1 2 3
2
4 5 6
7 8 9
0
4
DV VHS
TV CH +
BRAND CODE
51
51
50
41
40
STOP
1
DBS Receiver Multi-Brand
Remote Control
The VCR's remote control can control functions on the brands
of DBS (Direct Broadcast Satellite) receivers listed below.
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receiver's remote
control.
SET REMOTE CONTROL
MODE
2
Set the VCR/TV/CABLE/DBS switch on the VCR's
remote control to CABLE/DBS.
ENTER DBS RECEIVER BRAND
3
While holding down POWER on the VCR's remote
control, use the NUMBER keys to enter the DBS receiver
brand number from the chart below and then press STOP.
Follow the example shown at bottom left.
Once you have set the remote control to operate the
DBS receiver, you don't have to repeat this step until
you replace the remote control's batteries.
OPERATE DBS RECEIVER
4
First, press POWER to see if the DBS receiver's power
goes off as it should. If it does, try other functions (TV
CH +/– and the NUMBER keys can be used to operate
the DBS receiver).
For some brands of DBS receiver, you must press
ENTER after having pressed the NUMBER keys.
To return the remote to VCR control, set the VCR/TV/
CABLE/DBS switch to VCR.
NOTES:
You must set the DBS receiver brand for your remote control
and the DBS receiver brand for your Controller (
separately.
Depending on the type of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
It's not possible to operate a DBS receiver that is not
equipped with a remote control sensor.
Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
It's not possible to set the remote control for both your DBS
Release
receiver and a cable box at the same time. You can only set
the remote control to operate one of these units at a time.
SPECIAL FEATURES (cont.)
pg. 19)