Edit To Or From Another Vcr - JVC HR-S4600U Instructions Manual

50
EN
Edit To Or
From Another
VCR
AUDIO OUT
Player
S VIDEO OUT
S-Video cable
(supplied)
S VIDEO IN
Recorder
VIDEO IN
Advantages Of S-VHS Editing
S-VHS allows you to make high resolution video
recordings when dubbing from one VCR to another.
You can edit from VHS to S-VHS, from S-VHS to VHS, or
from S-VHS to S-VHS.
From VHS to S-VHS (VIDEO-VIDEO connection): Record
VHS playback signals in the S-VHS mode. Although the
picture quality is inherently limited by the original VHS
source material, the edited tape has better picture quality
than those made by VHS-to-VHS editing.
From S-VHS to VHS (VIDEO-VIDEO connection): Because
the picture quality of the source material is very high, the
edited tape has better picture quality than those made by
VHS-to-VHS editing.
From S-VHS to S-VHS (S-VIDEO connection): A high
resolution copy is made of a high resolution original S-
VHS tape with minimal picture degradation. This is the
preferred method of video dubbing.
Your VCR
VIDEO OUT
Audio/Video cable
(supplied)
AUDIO IN
Another VCR
You can use your VCR as the player or the recorder.
MAKE CONNECTIONS
1
Connect an AV cable between the player's VIDEO OUT
and AUDIO OUT connectors and the recorder's VIDEO
IN and AUDIO IN connectors.
If using another VCR with an S-VIDEO input or
output connector, it is recommended to use the S-
VIDEO connection to minimize picture degradation
while editing.
When using your VCR as the recorder and a monaural
VCR as the player, connect the player's AUDIO OUT
connector to the AUDIO IN L connector on the recorder.
LOAD CASSETTES
2
Insert the playback cassette into the player and the
cassette to be recorded on into the recorder.
SET RECORDER'S INPUT
MODE
3
Set to "AUX". With this VCR, press the NUMBER key "0"
and/or CH to select depending on the connector being
used – "L-1" for the rear AUDIO/VIDEO IN connector,
or "F-1" for the front AUDIO/VIDEO IN connector.
NOTE:
If you use your VCR as the recorder and have connected
another VCR to your VCR's S-VIDEO IN connector, you
need to set "REAR AUX INPUT" to "S-VIDEO" at the
Function screen. Follow steps 4 – 6 from the "Edit From
A Camcorder" section (
SELECT "EDIT" FOR PIC-
TURE CONTROL SET MODE
4
Follow the "Picture Control" section on page 26, then
select "EDIT."
NOTE:
When you select "EDIT" to dub tapes, be sure to select
"AUTO" (or "NORM" when "VIDEO CALIBRATION" is
set to "OFF") after you finish dubbing the tapes.
START PLAYER
5
Set to its play mode.
NOTE:
If the player is equipped with a superimpose/OSD
disable feature then set "SUPERIMPOSE" to OFF before
pressing PLAY (
START RECORDER
6
Set to its record mode.
NOTE:
If you use an auxiliary input to connect a cable box or DBS
receiver, make sure that the correct AUX INPUT mode ("VIDEO"
or "S-VIDEO") is selected after you have finished editing (
steps 4 – 6 on pg. 48 and 49).
EDITING (cont.)
pg. 48 and 49).
pg. 29).