Dbs Receiver Multi-Brand Remote Control - JVC HR-J456EN Instruction Manual

38
EN
CABLE/DBS
1
4
7
1
STOP
TV CH –
DBS BRAND NAME
ECHOSTAR (DISH Network)
PRIMESTAR
SONY (DSS)
RCA (DSS)
POWER
ENTER
2 3
2
NUMBER
5 6
8 9
0
4
TV CH+
BRAND CODE
51
50
41
40
SPECIAL FEATURES (cont.)
DBS Receiver Multi-Brand
Remote Control
The VCR's remote control can control functions on the brands
of DBS (Direct Broadcast Satellite) receivers listed below.
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receiver's remote
control.
ENTER DBS RECEIVER
BRAND
2
While holding down CABLE/DBS on the VCR's remote
control, use the NUMBER keys to enter the DBS receiver
brand number from the chart at bottom left and then
press STOP.
Follow the example shown below.
Once you have set the remote control to operate the
DBS receiver, you don't have to repeat this step until
you replace the remote control's batteries.
OPERATE DBS RECEIVER
3
Press CABLE/DBS and POWER in succession to see if
the DBS receiver's power goes off as it should. If it
does, try other functions.
To operate your DBS receiver, press CABLE/DBS first,
then press the corresponding button: POWER,
TV CH +/– and NUMBER keys (or ENTER).
Depending on the satellite receiver you may have to
press ENTER after having pressed the NUMBER keys.
NOTES:
Depending on the kind of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
It's not possible to set the remote control for both your cable
box and your DBS receiver at the same time; you can only set
the remote control to the brand of either one.
You have to subscribe to a satellite broadcaster to receive
DBS channels.
(Ex.) To set remote control to RCA 40:
CABLE/
DBS
4
Hold
Press in succession
down
0 STOP
Release