Auto Sp Ep Timer; Auto Timer - JVC HR-S4600U Instructions Manual

Auto SP EP Timer

If, when recording in SP mode, there is not enough tape to record
the entire program, the VCR automatically switches to EP mode to
allow complete recording. This feature is especially handy when
recording a program of more than 2 hours in length.
For Example . . .
Recording a program of 140 minutes in length onto a 120-
minute tape
Approximately 110 minutes
SP mode
Total 140 minutes
Make sure you set "AUTO SP EP TIMER" to "ON" at the
Function screen before the timer recording starts.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS FUNCTION SET
SCREEN
2
Move the highlight bar (arrow) to "FUNCTION SET" by
pressing CH 5 ∞ or SHUTTLE PLUS % fi, then press OK
or SHUTTLE PLUS
SELECT AUTO SP EP
TIMER SET MODE
3
Move the highlight bar
(arrow) to "AUTO SP EP
TIMER" by pressing CH
5 ∞ or SHUTTLE PLUS
% fi, then press OK or
#
SHUTTLE PLUS
"ON".
RETURN TO NORMAL
SCREEN
4
Press MENU.
NOTES:
If you have programmed the VCR to timer-record 2 or more
programs, the second program and those thereafter may not fit
on the tape if you set the Auto SP EP Timer mode to "ON". In
this case, make sure the mode is not engaged, then set the
tape speed manually during timer programming.
In order to ensure that the recording fits on the tape, this
feature may leave a slight non-recorded section at the end of
the tape.
There may be some noise at the point on the tape where the
VCR switches from SP to EP mode.
The Auto SP EP Timer feature is not available during ITR
(Instant Timer Recording), and the feature will work with the
following tapes: T(ST)-30, T(ST)-60, T(ST)-90, and T(ST)-120.
Approximately 30 minutes
EP mode
#
.
FUNCTION
VIDEO CALIBRATION
PICTURE CONTROL

AUTO TIMER

SUPERIMPOSE
= AUTO SP = EP TIMER
to set to VIDEO STABILIZER
NEXT PAGE
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
Auto Timer
When the Auto Timer is set to "ON" the timer is automatically
engaged when the VCR's power is turned off. It is automatically
disengaged when the VCR is powered back on.
ACCESS MAIN MENU
SCREEN
1
Press MENU.
ACCESS FUNCTION SET
SCREEN
2
Move the highlight bar (arrow) to "FUNCTION SET" by
pressing CH 5 ∞ or SHUTTLE PLUS % fi, then press OK
or SHUTTLE PLUS
SELECT AUTO TIMER SET
MODE
3
Move the highlight bar
(arrow) to "AUTO TIMER"
by pressing CH 5 ∞ or
SHUTTLE PLUS % fi, then
press OK or SHUTTLE
#
PLUS
"OFF".
RETURN TO NORMAL
SCREEN
ON
AUTO
OFF 4
Press MENU.
ON
ON
OFF
NOTE:
For safety, when AUTO TIMER is set to "OFF", all other VCR
functions are disabled while the Timer mode is engaged. To
disengage the timer, press TIMER.
#
.
VIDEO CALIBRATION
PICTURE CONTROL
= AUTO TIMER
SUPERIMPOSE
AUTO SP = EP TIMER
VIDEO STABILIZER
to set to "ON" or
NEXT PAGE
SELECT WITH (5,∞) AND (OK)
PRESS (MENU) TO END
45
EN
FUNCTION
ON
AUTO
OFF
ON
ON
OFF