Wiring The Actuators; Rf Remote Control; Removing Remotes - Gatekeeper YG-5602 Owner's Manual

Wiring the Actuators

To wire the actuators into the Control Box:
1. Connect the Master or Number 1 gate actuator wires to the J1 Master terminal.
a. Pull to Open: Connect the white wire to the + terminal and the black wire
to the – terminal.
b. Push to Open: Connect the white wire to the – terminal and the black wire
to the + terminal.
2. Connect the wires from the slave actuator to the J2 Slave terminal.
a. Pull to Open: Connect the white wire to the + terminal and the black wire
to the – terminal.
b. Push to Open: Connect the white wire to the – terminal and the black wire
to the + terminal.
If using a single gate, connect the active actuator to the J1 Master terminal.

RF Remote Control

Press button SW2/Code Learn on the Control Board. You will notice that an LED turns
on the control board indicating that the "RF Remote Learning Mode" is active.
During the "RF Remote Learning Mode" period, press Button 1 on the remote control so
the board can memorize the remote's frequency. After the LED light turns off, the
receiver module goes back to "Normal" mode.
The Gatekeeper YG supports up to 15 remote controls. Repeat the RF Remote Learning
Mode for each additional remote.
You can order additional RF Remote controls through your dealer (found under
"Dealers" on www.gatekeeperltd.com).

Removing Remotes

You can clear the Control Box memory of all remote control information by pressing the
SW2/Code Learning button and keeping the button depressed for 10+ seconds.
You will then need to 'relearn' the remotes that you want active by pressing the
SW2/Code Learning button as explained in the section above.
page 25