Installation
The actual installation of the Gatekeeper YG will take about four hours, if all goes well.
Completing the "Pre-installation Checklist' will expedite the installation process. Ensure
you have sufficient time so you can complete the installation once you begin.
There is not a 'good' stopping place in the installation.
Tools and Equipment
The following items may be necessary to install the Gatekeeper YG:
Standard and Philips screw drivers
Electric drill
Wire cutters
Wire stripper
Socket set
Welder
Adjustable wrench
Tarp or tray to hold large items
Dish or bowl to contain small parts
First aid kit
Installation instructions
Gate Arm (Actuator) Installation
The YG-5602 gate operator operates by forcing a worm gear to extend inside each
actuator pushing or pulling the gate open.
Install the actuator mechanism inside of the property, inside of the fence, so that it cannot
be tampered with from outside of your property. Initially mount the actuators on the gate
so that the gate is open.
Be sure to unlock the linear actuators with the key.
Determine Gate Open Direction
Begin with both openers unlocked. Next, identify if this will be a "push to open" or a
"pull to open" installation. In either configuration, the gate mounts on one face of the
mounting post, and the opener mounts on the face 90 degrees from it.
The following sections explain the "push to open" and "pull to open" configurations.
page 15