Wiring The Battery - Gatekeeper YG-5602 Owner's Manual

CAUTION! Make sure that the power is OFF at the source and is not
connected to the Control Box before making any electrical connections.
BEWARE!
The battery is not secured when the Control Box is open.
Open the box carefully so the battery does not fall out, damaging the unit
or your foot.
Open the box carefully. Using the above diagram, complete these steps:
1. Wire the AC line into the AC IN terminal at the top of the control box near the
transformer.
a) Wire the ground (usually green) to the terminal on the left.
b) Wire the hot (usually black) wire to the middle terminal.
c) Wire the neutral (usually white) wire to the terminal on the right.
2. Verify that all electrical connections are waterproof by installing electrical outlets
into exterior grade boxes with waterproof covers. Always ensure that when any
electrical connections through the Control Box are sealed and weatherproof.

Wiring the Battery

Verify that the Battery is connected to the Control Board.
1. Connect the red battery lead to the 'BAT+' terminal of the battery (if not already
connected.).
2. Connect the black battery lead to 'BAT-' terminal of the battery (if not already
connected).
3. Connect the white connector from the battery to (J8) DC 12V Battery INPUT on the
main board (see diagram next page).
page 21