Electric Lock Cross Section
The following illustrates the electric latch assembly as a cross section. Weld the L Bar
and electric lock to the gate for the most secure closure.
The L Bar controls the offset of the gate leaf from the Gate Stopper. The Electric Lock
attaches to the slave gate and contacts the Stop Block. The L Bar is welded to the master
gate ensuring the master gate lines up with the slave gate when closed. The Bar
Mounting Bracket is used to trap the master gate. Install the Bar Mounting Bracket on
the slave gate so that it keeps the master gate from opening once the slave gate closes and
latches.
This drawing illustrates the mechanism form above:
page 19