V-Com Adjustment (Pd-92/93 Board); White Balance Adjustment (Pd-92/93 Board) - Sony Handycam CCD-TRV3E Service Manual

8. V-COM Adjustment (PD-92/93 board)

Set the DC bias of the common electrode drive signal of LCD to the
specified value.
If deviated, the LCD display will move, producing flicker and
conspicuous vertical lines.
Mode VTR stop
Signal No signal
Measurement point Check on LCD display
Measuring instrument
Adjustment page E
Adjustment address D7
Specified value The brightness difference between the
section A and section B is minimum.
Note1 : Perform "Bright Adjustment" and "Contrast Adjustment"
before this adjustment.
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 01, set data: 51, and press the PAUSE
button of the adjusting remote commander.
3) Select page: 2, address: 7D, and set data: 87.
4) Select page: E, address: D7, change the data so that the brightness
of the section A and that of the section B is equal.
5) Press the PAUSE button of the adjusting remote commander.
6) Select page: 3, address: 01, set data: 00, and press the PAUSE
button of the adjusting remote commander.
7) Select page: 2, address: 7D, and set data: 00.
8) Select page: 0, address: 01, and set data: 00.
B
A
B
A
Fig. 5-1-24.
A
B
A
B
5-30

9. White Balance Adjustment (PD-92/93 board)

Correct the white balance.
If deviated, the LCD screen color cannot be reproduced.
Mode VTR stop
Signal No signal
Measurement point Check on LCD display
Measuring instrument
Adjustment page E
Adjustment address D1, D2
Specified value The LCD screen should not be colored.
Note1: Check the white balance only when replacing the following
parts. If necessary, adjust them.
1. LCD panel
2. Light induction plate
3. IC5502/4502
Note2 : LCD TYPE S NTSC model :
LCD TYPE S PAL model : CCD-TRV23E/TRV45E/
LCD TYPE C model : CCD-TRV3E/TRV13E
Adjusting method:
1) Select page: 0, address: 01, and set data: 01.
2) Select page: 3, address: 01, set data: 51, and press the PAUSE
button of the adjusting remote commander.
3) Select page: 2, address: 7D, and set data: 03.
4) Select page: E, address: D1 and D2, and set the data to the initial
value.
Note:
To write in the non-volatile memory (EEPROM), press
the PAUSE button of the adjusting remote commander each
time to set the data.
Address Data
LCD TYPE S LCD TYPE C
NTSC PAL
D1 98 94
D2 88 81
5) Check that the LCD screen is not colored. If colored, change the
data of page: E, address: D1 and D2 so that the LCD screen is
not colored.
Note: To write in the non-volatile memory (EEPROM), press
the PAUSE button of the adjusting remote commander each
time to set the data.
6) Select page: 3, address: 01, set data: 00, and press the PAUSE
button of the adjusting remote commander.
7) Select page: 2, address: 7D, and set data: 00.
8) Select page: 0, address: 01, and set data: 00.
CCD-TRV75/TRV75PK/TRV715
TRV55E/TRV65E/TRV69E
PAL
97
8D