Display; Battery Name Editing; Charge Page; Lipo, Liion, Life Battery Charge Setup - GRAUPNER Polaron Operating Instructions Manual

Display

Section 1
Section 2
1) Tap the memory number box in section 1 to activate. Tap the INC/DNC buttons to set the memory number.
The numbers 0-19 are available and changeable. Press and hold the memory number box to access
the battery name page.
2) Tap the battery type, the number of cells and the capacity to activate these functions. Tapping the INC/DEC
buttons can be used to edit the battery parameters.
3) Memory copy
Tap the number box in Section 2 to activate. Tap the INC/DNC buttons to set the memory number.
Tap the CPY button to copy the battery parameters from Section 1 to the battery parameters
for Section 2.
4) Tap CPY button to store the battery parameters and tap ESC button to get back to the previous page
IMPORTANT: The battery parameters must be entered correctly, as incorrect values may
cause the charger to damage your battery, which can result in a fire!

Battery name editing

Battery names can be written with 12 characters. Tapping the Clr button (shown in the red circles, above) erases the
default name, allowing the new name to be entered. To enter the battery names "ABC", "abc", or "123", each
page with the upper case letters, the lower case letters and the numbers with special characters should be separately
accessed by tapping the respective icons. Tapping the ESC button will return the screen to the previous page.
13
Memory number & Battery name
Battery type
Battery Cell quantity and Voltage
Battery capacity

◎ CHARGE PAGE

To access the charge mode, tap the CHARGE icon on the main page. The parameters in this mode
are dependant on the selected battery type that was set on the profile page.
USER NAME
The battery parameters
The battery parameters
on the charge page for
on the charge page for the
the LiPo, Lilon, LiFe
batteries
To program the battery parameters, tap each data box, activating to a blue color. To edit the
battery parameters, tap the INC/DEC buttons.

LiPo, LiIon, LiFe battery charge setup

- Voltage : Maximum cell voltage - CV (Constant Voltage)
- Current : Charge current. - Tapping the INC/DEC buttons can activate and edit the
parameters The default charge current is set to 1C (1 x capacity).
This value can be adjusted from
0.1 to 8.0 Amps, operating within the 120W limitation.
Tap the CHARGE icon on the main
page to initiate the charging process.
The battery parameters
on the charge page for the
Pb batteries
NiCd, NiMH batteries
14