Balance Page; Data View Page - GRAUPNER Polaron Operating Instructions Manual

Pressing the
to appear, asking for a confimation that you want to stop
the operation. Tapping either the STOP or ESC button will
cause the charger to either stop or continue the cycle,
respectively.

◎ BALANCE PAGE

Tapping the BALANCE icon on the main page will access the balance mode. Tap the DEC/INC Buttons
to toggle between the 3 modes. Tap the Enter button to initiate the balancing process. The selected
mode is used with the batteries that are equipped with a cell balance connector (LiPo, LiIon, LiFe
batteries).
LiPo, Lilon, LiFe battery balance page
This page (left) displays the connected battery
parameters.
Tapping will activate the box (blue). The battery memory
can then be selected.
27
button will cause the pop-up window
Tap the BALANCE icon to access the balance
mode.
(The balance connector should be installed.)
▲ BALANCE MODE 1 ▲ BALANCE MODE 2
1) BALANCE MODE 1 : This page (above, left) shows the basic date of the battery.
2) BALANCE MODE 2 : This page (above, center) shows the cell voltage and internal
impedance values.
3) BALANCE MODE 3 : This page (above, right) displays multiple parameters.
- Center Voltage(Vc): The voltage of the center in the Y axis.
- Range Voltage(Vr) : The voltage range of every section in the Y axis
- Manual / Auto
Manual: The graph can be manually operated. Tap the data box to activate. Tap the DEC/INC
buttons to program the parameters. The Center Voltage and Range Voltage can
be activated and programmed using the manual setup.
Auto: This mode performs an automatic setup of the graph for the operation.
Each cell voltage is activated and checked.
- Cell Voltage : Displays the cell voltage. Tapping activates this paramter, allowing the cell data to
be checked.

◎ DATA VIEW PAGE

Tap the DATA icon on the main page to access the data view mode. There are 3 view modes. After
activating the buttons, the data can be programmed by tapping the DEC/INC buttons. In the Cycle data
and Graph data modes, the data can be accessed. In the Normal data mode, the parameters can not
be programmed.
Center voltage
Range voltage
Cell Voltage
Manual / Auto
▲ BALANCE MODE 3
Tap the DATA icon to check the charge/discharge
data on the main page.
28