Default VLANs
The Switch initially configures one VLAN, VID = 1, called "default." The factory default setting assigns all ports on the
Switch to the "default."
Packets cannot cross VLANs. If a member of one VLAN wants to connect to another VLAN, the link must be through an
external router.
An example is presented below:
VLAN Name
System (default)
Engineering
Marketing
Finance
Sales
VLAN and Trunk Groups
The members of a trunk group have the same VLAN setting. Any VLAN setting on the members of a trunk group will
apply to the other member ports.
Static VLAN Entry
In the Configuration folder, open the VLANs folder and click the Static VLAN Entry link to open the following window:
DGS-3024 Gigabit Ethernet Switch Manual
NOTE: If no VLANs are configured on the Switch, then all packets will be
forwarded to any destination port. Packets with unknown source
addresses will be flooded to all ports. Broadcast and multicast packets will
also be flooded to all ports.
VID
1
2
3
4
5
Table 7- 2. VLAN Example - Assigned Ports
NOTE: In order to use VLAN segmentation in conjunction with port trunk
groups, you can first set the port trunk group(s), and then you may
configure VLAN settings. If you wish to change the port trunk grouping
with VLANs already in place, you will not need to reconfigure the VLAN
settings after changing the port trunk group settings. VLAN settings will
automatically change in conjunction with the change of the port trunk
group settings.
Switch Ports
5, 6, 7, 8, 21, 22, 23, 24
9, 10, 11, 12
13, 14, 15, 16
17, 18, 19, 20
1, 2, 3, 4
55