D-Link DGS-3024 Manual page 39

Managed 24-port gigabit ethernet switch
Hide thumbs Also See for DGS-3024:
Table of Contents

Advertisement

Telnet Status
Telnet TCP Port
Number (1-65535)
Web Status
Web TCP Port
Number (1-65535)
RMON Status
GVRP
Link Aggregation
Algorithm
Switch 802.1x
Syslog State
DGS-3024 Gigabit Ethernet Switch Manual
IP router. The default is Disabled.
This indicates if a Telnet connection is currently enabled on the Switch. The default is
Enabled.
The TCP port number. TCP ports are numbered between 1 and 65535. The "well-
known" TCP port for the Telnet protocol is 23.
Web-based management is Enabled by default. If you choose to disable this by select-
ing Disabled, you will lose the ability to configure the system through the web interface
as soon as these settings are applied
The TCP port number currently being utilized by the Switch to connect to the web
interface. The "well-known" TCP port for the Web interface is 80.
This indicates if RMON is enabled on the Switch. The default is Disabled.
This indicates if Group VLAN Registration Protocol (GVRP) is enabled on the Switch.
GVRP is a protocol that allows members to dynamically join VLANs. The Switch's
GVRP settings can be changed on the GVRP Settings window (Configuration →
VLANs → 802.1Q Port Settings). The default is Disabled.
The algorithm that the Switch uses to balance the load across the ports that make up
the port trunk group is defined by this definition. Choose MAC Source, MAC
Destination, or MAC Src & Dest, (For further information, see the Link Aggregation
section, under the Link Aggregation folder).
The Switch's 802.1x function may be enabled by port; the default is Disabled. This field
must be enabled to view and configure certain windows for 802.1x. More information
regarding 802.1x, its functions and implementation can be found later in this section,
under the Port Access Entity folder. Port-Based 802.1x specifies that ports configured
for 802.1x are initialized based on the port number only and are subject to any
authorization parameters configured.
This allows you to enable or disable the System Log State. The default is Disabled.
25

Advertisement

Table of Contents
loading

Table of Contents