D-Link DGS-3024 Manual page 124

To delete an existing SNMP Group Table entry, click the corresponding
To display the current settings for an existing SNMP Group Table entry, click the hyperlink for the entry under the Group
Name.
To add a new entry to the Switch's SNMP Group Table, click the Add button in the upper left-hand corner of the SNMP
Group Table window. This will open the SNMP Group Table Configuration window, as shown below.
The following parameters can be set:
Parameter Description
Group Name
Read View Name
Write View Name
Notify View Name
DGS-3024 Gigabit Ethernet Switch Manual
Figure 9- 9. SNMP Group Table Display window
Figure 9- 10. SNMP Group Table Configuration window
Type an alphanumeric string of up to 32 characters. This is used to identify the new
SNMP group of SNMP users.
This name is used to specify the SNMP group created can request SNMP mes-
sages.
Specify a SNMP group name for users that are allowed SNMP write privileges to
the Switch's SNMP agent.
Specify a SNMP group name for users that can receive SNMP trap messages
generated by the Switch's SNMP agent.
under the Delete heading.
110