Advertisement
At this height, the PIR sensor detects motion up to 6.5 feet (2 meters) away, with a viewing angle up
to 80 degrees.
To help avoid false activation, mount your camera:
* Away from direct sunlight
* Away from heat sources, such as space heaters, radiators, and exposed light bulbs
* Away from strong drafts, like those caused by central heating vents
1. Prepare the mounting space by first removing the original door peephole hole viewer. If there is
no peephole, then you will need to drill a hole of an at least ½" (12.5mm) diameter at desired
location.
2. Clean the surface where the PIR camera sensor is to be mounted.
3. Carefully pull out the ribbon cable from the camera tube.
4. Remove the backing of the double-sided adhesive tape on the back of the PIR. Carefully feed the
ribbon cable and tube through the peephole to the other side of the door. Be careful not to stick
the camera to the door. Once you have the camera aligned properly, press the camera to the door
allowing the adhesive tape to the camera in place. As illustrated below, keep the PIR sensor on
the top.
5. Remove the backing of the double-sided adhesive tape on the back of the mounting bracket.
Carefully feed the ribbon cable through the mounting hole of the mounting bracket. Once you
have the mounting bracket aligned properly, press it to the door allowing the adhesive tape to the
mounting bracket in place.
7
Advertisement
