Installation - JVC HR-J270EK Instructions Manual

2

INSTALLATION

CONNECT VIDEO RECORDER TO TV
Place the recorder on a stable, flat surface.
Back of TV
Aerial connector
21-pin AV input connector
(SCART)
Mains Power Cord
Mains outlet
RF CONNECTION
To connect to a TV with NO 21-pin AV input connector
(SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the RF OUT jack on
the rear panel of the recorder and the TV's aerial connector.
ATTENTION
Do NOT Plug the mains power cord into a mains outlet until all connections are completed.
Do NOT press the
power before you start the Auto Set Up procedure described on page 6.
21-pin SCART Cable (not provided)
Make this connection
if your TV has a 21-pin
AV input connector
(SCART) in order to reduce
the possibility of interference.
And if you are using a stereo
TV, you will need this cable
in order to enjoy stereo
playback of videotapes.
button on the recorder or on the remote control to turn on the recorder's
RF Cable (provided)
L-2
( )
ENTREE/DECODEUR
AV2
IN/DECODER
AV CONNECTION
To connect to a TV with 21-pin AV input connector (SCART) . . .
1– Connect the aerial, recorder and TV as per "RF CONNECTION".
2– Connect an optional SCART cable between the AV1 (L-1)
IN/OUT socket on the rear panel of the recorder and the TV's
21-pin AV input connector (SCART).
AFTER YOU FINISH THIS STEP
TV Aerial Cable
(not provided)
ENTREE
CONTROLEUR SAT
ANT. IN
SORTIE
SAT CONTROL
OUT
L-1
( )
ENTREE/SORTIE
ANTENNE
AV1
R
IN/OUT
SORTIE
RF OUT
AUDIO
L
Back of Recorder
Go to Step 3 – AUTO SET UP
5