JVC HR-J270EK Instructions Manual page 21

1 2
4
5
8
7
0
START+/–
?
1
PROG
– –:– –
3
2
6
9
4
PR+/–
SP/LP
OK
When programmes overlap
each other
If "PROGRAM OVERLAPPED" appears, you have another
programme overlapping the programme you have just made.
The Program Check screen appears and conflicting programmes
will start blinking.
START STOP CH DATE
1 8 : 00 10 : 00 3 24 . 12
2 10 : 00 10 : 45 PROGRAM OVERLAPPED 2 25 . 12
3 11 : 30 13 : 00 1 25 . 12
4
5
6
7
8
[ ] : NEXT
EX. Programme 1 (you have just made) and
Programme 4 overlap each other.
CONFIRM OVERLAPPING
PROGRAMMES
1
Overlapping programmes blink on the screen.
SELECT PROGRAMME TO
MODIFY
2
Press %fi, then press OK or
You can only select one of the overlapping
programmes.
NOTE:
If you do not mind this overlap, press PROG to finish
the timer programme setting. The programme with the
lower programme number will be recorded and the
other one will not be recorded correctly. Without doing
anything for about 1 minutes, the recorder will finish
the timer programming.
CANCEL OR CHANGE
PROGRAMME SETTING
3
To cancel a programme,
press when the Program
screen you do not want is
shown. "PROGRAM
COMPLETED" appears on
the screen for about 5
seconds, then normal
screen appears.
To change a programme,
press the appropriate
button: START+/–, STOP+/–, DATE +/–, PR +/–, SP/LP
( ) and/or PDC when the Program screen on which
you want to make changes is shown, then press OK.
"PROGRAM COMPLETED" appears on the screen for
about 5 seconds, then normal screen appears.
NOTE:
If the overlap is not yet solved or another overlap
occurs with the timer programme setting made last after
making correction on a programme, the conflicting
programmes will be shown on the Program Check
screen again. Repeat the above steps again until the
overlap is solved.
21
START STOP CH DATE
1 8 : 00 10 : 00 3 24 . 12
2 10 : 00 10 : 45 2 25 . 12
3 11 : 30 13 : 00 1 25 . 12
4 9 : 00 10 : 00 92 DAILY
5
6
7
8
[5∞] =
[PROG] : EXIT
#
.
– P1 –
START STOP
=
8:00 10:00
SP VPS/PDC OFF
DATE TV PROG
24.12 3
ITV
[+/–] =
[ ] : DELETE
[PROG] : EXIT