DAELIM B-Bone Service Manual page 71

Check the MAPAT Circuit(Intake Pressure Sensor (IMP)+Intake Temperature Sensor(TBA))'s circuit
Fault code number is displayed by MIL
The Fault code of intake pressure sensor
Checking circuit
MAPAT
ECU
Coupler terminal is based on the side of wire-harness
Checking Procedure
1) Turn off the ignition key .
2) Check to see if the MAPAT coupler has come loose or the wire is peeling off.
If there is normal, measured the input voltage of MAPAT's coupler.
3) Disassemble the coupler of MAPAT and turn on the ignition key
4) Measure the input voltage of MAPAT (intake pressure sensor + intake temperature sensor)'s coupler.
Input voltage : 4.5 ~ 5.5[V]
Measuring terminal :
Remarks : Measuring unit of voltage : voltage [V]
If voltage value is not normal,
Check to see if the ECU coupler is loose or if there is a bad contact.
Check the 'P' electric wire, 'P/G' electric wire, 'P/L' to see if they have been broken short-circuited
Remark : refer to (5-20) if the intake pressure sensor is broken
refer to (5-20) if the intake temperature sensor is broken
5)After fault repaired, To erase the memorized fault code in the ECU is refer to how to remove the fault code(5-10).
The Fault code of intake temperature sensor
MAPAT 3 terminal ~ MAPAT 1 terminal
EMS(Engine Management System)
3 : Intake pressure sensor ground
3 : Inhalation pressure
26 : 5V voltage
sensor GROUND
27 : IMP
26 : 5V voltage
28 : TBA
27 : IMP 28 : TBA
5-19