DAELIM B-Bone Service Manual page 107

SCREW SET SCREW SET SCREW SET SCREW SET SCREW SET
SCREW SET SCREW SET SCREW SET SCREW SET
SCREW SET SCREW SET SCREW SET SCREW SET SCREW SET SCREW SET
SCREW SET SCREW SET SCREW SET SCREW SET SCREW SET SCREW SET SCREW SET
TOP SET TOP SET TOP SET TOP SET TOP SET
TOP SET TOP SET TOP SET TOP SET
TOP SET TOP SET TOP SET TOP SET TOP SET TOP SET
TOP SET TOP SET TOP SET TOP SET TOP SET TOP SET TOP SET
FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET
FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET
FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET
FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET FLOAT CHAMBER SET
ASSEMBLY
● Install the needle jet, needle jet holder, main jet and
slow jet.
● Tighten the pilot jet until it seat lightly, then turn it out
as much as number recorded during removal.
● Install the pilot jet rubber.
● Install the float valve set, float comp, float pin.
● Measure the float level with the float valve gauge.
FLOAT LEVEL : 13 mm
TOOL : FLOAT COMP LEVEL GAUGE
● Install the float chamber set.
● Install the stay plate set and 4 pan screws.
NOTE
!
Be sure to replace the float chamber body O-ring
with the new one.
● Install the valve plate set, compression spring in the
vacuum piston comp.
NOTE
!
Install the jet needle aligned with the grooves.
● Install the diaphragm cover with its cutout aligned with
the cover.
● Place the top set on the spring.
● Tighten the 2 special pan screws.
FUEL SYSTEM
6-7