Installation - JVC HM-DR10000EK Instructions Manual

6
2

INSTALLATION

CONNECT VIDEO RECORDER TO TV
Place the recorder on a stable, flat surface.
Back of TV
21-pin AV input
connector (SCART)
Mains outlet
Mains power inlet
ATTENTION:
You can not use the recorder connected to your TV only with the RF cable. This is because the RF cable does not deliver signal
from the recorder. Your TV must have a 21-pin AV input connector (SCART) to connect to the recorder.
AV CONNECTION
To connect to a TV with 21-pin AV input connector (SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the ANT. OUT jack on
the rear panel of the recorder and the TV's aerial connector.
AV1 INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNECTION
The AV1 IN/OUT connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in which the
luminance and chrominance signals are separated). For input signal selection, select "VIDEO" (regular video signal) or "S-VIDEO"
(Y/C signal) for "AV1 SELECT" setting (
If your TV's 21-pin AV input connector (SCART) is compatible only with the regular video signal, set this switch to COMP.
If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set this switch to Y/C. You can obtain high-
quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)
NOTES:
Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.
For switching the TV's mode, refer to the instruction manual of your television.
To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 7.
ATTENTION
Do NOT plug the mains power cord into a mains outlet until all connections are completed.
Do NOT press the
power before you start the Auto Set Up procedure described on page 8.
Aerial connector
21-pin SCART Cable (provided)
AV1 OUT switch
S OUT
pg. 50). For output signal selection, use the AV1 OUT switch on the rear panel.
button on the recorder or on the remote control to turn on the recorder's
QUICK SET UP GUIDE (cont.)
RF Cable
(provided)
AV1 IN/OUT
SYNCHRO EDIT
JLIP
R.PAUSE
AV1 OUT
S IN
L
(S-1) COMP. Y/C
AV1 IN/OUT (L-1)
AUDIO
R
OUT IN (S-1)
AV2 IN/DECODER
(L-2)
DV IN
4– Connect the provided SCART cable between the AV1 IN/OUT
socket on the rear panel of the recorder and the TV's 21-pin
AV input connector (SCART).
5– Set the AV1 OUT switch to the appropriate position. See "AV1
INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNEC-
TION" below.
TV Aerial Cable
(not provided)
ANT. IN
ANT. IN
ANT. OUT
ANT. OUT
Back of Recorder