Automatic Satellite Programme Recording - JVC HM-DR10000EK Instructions Manual

40
Automatic Satellite
Programme Recording
This facility allows you to record automatically a satellite programme which is timer-programmed on your external satellite receiver.
Connect a satellite receiver to the recorder's AV2 IN/DECODER connector and programme the timer on the satellite receiver; the
recorder starts recording when the signals input from the satellite receiver to the AV2 IN/DECODER connector, and when there is no
input signals the recorder stops recording and the power shuts off.
Satellite Receiver Unit
DECODER
Mains outlet
S-VIDEO
OUT
Back of Recorder
AV1 OUT switch
IMPORTANT
When you set "AV2 SELECT" to "SAT" (
if the recorder is in Timer mode, in Stop mode, recording or turned off. When the recorder is in Stop mode or recording, press
TV/VCR on the remote control to turn off the VCR indicator on the display panel.
In this case, be sure to set the AV1 OUT switch on the rear panel to COMP.
NOTES:
Set the satellite receiver's output mode to Composite.
Refer to the instructions supplied with your satellite receiver.
Outdoor Unit
Satellite Cable
VCR TV
AV1 OUT
S OUT S IN
COMP. Y/C
(S-1)
AV1 IN/OUT
AV2 IN/DECODER
DV IN
pg. 50), it is possible to view a satellite broadcast with the TV set to its AV mode even
ADVANCED OPERATIONS (cont.)
Aerial
TV Aerial cable
ANT. IN
RF OUT
SYNCHRO EDIT
JLIP
R.PAUSE
L
(L-1)
AUDIO
R
OUT IN
(S-1)
(L-2)
Back of TV
S-VIDEO IN
connector
Aerial
connector
AUDIO IN
connectors
ANT. IN
ANT. OUT
21-pin AV input
connector (SCART)