Dv Sound Setting - JVC HM-DR10000EK Instructions Manual

A If the camcorder has no S-VIDEO output connector...
AUDIO input
VIDEO
input
Audio Cable (not provided)
Video Cable (not provided)
VIDEO OUT
Player
Camcorder
AUDIO OUT
EDIT
C If the camcorder has a DV OUT connector...
Recorder
DV IN
DV Cable
(provided)
Player
DV OUT
DV Camcorder
EDIT
Recorder
To rear panel
R.PAUSE connector
Mini-Plug Cable
(not provided)
(JVC camcorder
only)
R.PAUSE connector
Mini-Plug Cable
(not provided)
(JVC camcorder only)
B If the camcorder has an S-VIDEO output connector...
AUDIO input
S-VIDEO
input
Audio Cable (not provided)
S-Video Cable (provided)
S-VIDEO OUT
Player
Camcorder
AUDIO OUT
EDIT

DV Sound Setting

Up to four audio signal channels can be input from a DV
camcorder through the DV IN connector (i.Link). This
recorder allows you to select and record two of these
channels. This setting is used to specify which two
channels to record.
1
Press MENU to access the Main Menu screen.
2
Move the highlight bar (pointer) to "MODE SET" by
pressing % fi, then press OK or
3
Move the highlight bar (pointer) to "DV SOUND" by
pressing % fi, then press OK or
"SOUND2" or "FULL".
MODE SET
B. E. S. T.
PICTURE CONTROL
AUTO TIMER
O. S. D.
DIRECT REC
AUTO SP=LP TIMER
DIGITAL 3R
NEXT PAGE
[5∞] =
[MENU] : EXIT
When there are four DV audio channels (32kHz):
SOUND1: Records the two channels (L/R) of DV
SOUND 1.
SOUND2: Records the two channels (L/R) of DV
SOUND 2.
FULL: Mixes and records both DV SOUND 1 and
2.
When there are two DV audio channels (48kHz):
Because there are only two channels, those two
channels are recorded regardless of the DV sound
setting.
4
Press MENU to return to the normal screen.
Recorder
To rear panel
R.PAUSE connector
Mini-Plug Cable
(not provided)
(JVC camcorder
only)
#
.
#
to select "SOUND1",
PREVIOUS PAGE
ON POWER SAVE
AUTO S-VHS
OFF AV1 SELECT
ON AV2 SELECT
ON DV SOUND
OFF AUDIO REC
ON
[5∞] =
[MENU] : EXIT
47
OFF
AUTO
VIDEO
AV2
SOUND1
NICAM