Video Plus+ Timer Programming - JVC HM-DR10000EK Instructions Manual

18
VIDEO Plus+
Timer Programming
Before performing the VIDEO Plus+ Timer Programming:
Make sure that the recorder's built-in clock is set properly.
Insert a cassette with the safety tab in place. The recorder
will come on automatically.
Set the appropriate recording mode (D-VHS, S-VHS or
VHS) ( pg. 14, 15).
Turn on the TV and select the AV mode.
TIMER
LCD panel
1
1
LCD PROG
2
2
NUMBER
5
PDC
1
1,6
PROG
2
You can use the remote control with LCD panel to enter the
PlusCode number.
ACCESS VIDEO PLUS+ DISPLAY
1
Press LCD PROG.
The LCD panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to enter the PlusCode number of
a programme you wish to record, then press .
If you make a mistake, press
number.
The PlusCode number you enter appears on the LCD panel:
Then go to step 3 in the right column.
®
‰ TIMER indicator
– –:– –
1 2 3
4 5 6
3
4
7 8 9
4
STD/LS3 (SP/LP)
0
3
STOP+/–
and input the correct
BASIC OPERATIONS (cont.)
With the VIDEO Plus+ system, timer programming is greatly
simplified because each TV programme has a corresponding
code number which your recorder is able to recognise.
ACCESS VIDEO PLUS+ SCREEN
1
Press PROG.
The front display panel looks like this:
ENTER PLUSCODE NUMBER
2
Press the NUMBER keys to
enter the PlusCode number
of the programme you
wish to record, then press
OK.
The PlusCode number you enter appears on the front
display panel:
2
The display panel shows only a 4-digit number.
7
4
ACCESS VIDEO PLUS+ PROGRAM
SCREEN
3
2,6
The VIDEO Plus+ Program
OK
screen appears (if you're
just starting out, "P1"
appears).
The display panel shows the
programme start time.
Pressing
display to the programme
stop time, then the date and
preset position.
If you make a mistake,
press and input the
correct number.
changes the
IMPORTANT
Make sure the preset position number you wish to
record is displayed; if not, see "VIDEO Plus+
Setup" on page 65 and set the Guide Program
number for that PlusCode number correctly.
If the number you entered is invalid, "ERROR" appears
on the screen and "Err" appears on the display panel.
Press and input a valid PlusCode number.
If the "GUIDE PROG SET" screen appears, see
"ATTENTION – Regarding Guide Program Number
Set" on page 19.
V I D EO P LU S +
[0 – 9] : VIDEO PLUS+
[+/–] : EXPRESS PROGRAMING
[PROG] : EXIT
V I DE O P LU S +
1 2 3 4 5 6 7 8
[0 – 9] =
[ ] : DELETE
[PROG] : EXIT
– P1 –
VIDEO PLUS+ 123456789
START STOP
=
21:00 22:00
SP(STD) VPS/PDC OFF
DATE TV PROG
25.12 1
BBC 1
: OK
SP
®