Recording - JVC HM-DR10000EK Instructions Manual

14

Recording

TV signals being received by the recorder's built-in tuner can be
recorded onto a video tape. You can "capture" a TV programme
using your video recorder.
Turn on the TV and select the AV mode.
Insert a D-VHS cassette to record in the D-VHS mode.
STD indicator
5
5
4
6
2
1
2
4
NUMBER
7
1
2
6
4
RECORD
2
LS3 indicator
3
2
6
2 3
5 6
3
4
8 9
4
STD/LS3 (SP/LP)
0
3
TV PROG
4,5
PLAY
PAUSE
BASIC OPERATIONS (cont.)
D-VHS Recording
LOAD A CASSETTE
1
Insert a cassette with the record safety tab intact (See
next page).
The counter is reset to 0:00:00 and the recorder
power comes on automatically.
While "– – – –" is blinking on the front display panel,
the tape will run for a few seconds to search for the
tape number.
The STD (or LS3) indicator lights and the D-VHS
recording mode is selected automatically.
CHOOSE A PROGRAMME
2
Press TV PROG +/– or the NUMBER keys to select the
preset you wish to record.
The TV PROG dial can also be used to select a
channel.
SET TAPE SPEED
3
Press STD/LS3 (
to confirm the selected tape speed.
START RECORDING
4
Press and hold RECORD and press PLAY on the remote
control, or press RECORD on the recorder.
If "DIRECT REC" is set to "ON", the programme
that appears on the TV screen will be recorded
( pg. 11).
You can not change the preset whilst recording is in
progress. To change the preset, see step 5.
PAUSE/RESUME
RECORDING
5
Press PAUSE. Press PLAY to resume recording.
During the Record Pause mode, you can change the
preset by pressing the TV PROG +/– buttons or the
NUMBER keys.
STOP RECORDING
3
6
Press STOP. Then press EJECT to remove the cassette.
NOTE:
2
To record in the S-VHS or VHS mode on a D-VHS cassette,
press D-VHS so that the STD (or LS3) indicator goes off (
32).
5
). Check the STD or LS3 indicator
pg.