Remote Control Functions - JVC HM-DR10000EK Instructions Manual

42
Remote
Control
Functions
Remote control code switch
VCR
1
2
1
NUMBER "1"
4
7
1
2
– –:– –
2 3
5 6
3
4
8 9
4
0
3
OK
ADVANCED OPERATIONS (cont.)
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
SET REMOTE CONTROL
CODE
1
Slide the remote control code switch on the recorder to
"B".
AND
Press and hold VCR on the remote control for over 2
seconds, press the NUMBER key "2" and then press OK.
NOTES:
To set the recorder back to respond to A code signals, repeat
the same procedure as shown above, except sliding the
remote control code switch to "A" and pressing NUMBER key
"1" instead of "2" in step 1.
If you don't want to control the recorder by the remote
control, slide the remote control code switch to "OFF".