Step 4 Connect Power; Step 5, Slide Product Into Cutout; Step 6 Set Temperature Controls - Monogram ZIDI240 Design And Installation Manual

STEP 4 CONNECT POWER

• Connect power cord plug to a properly grounded
receptacle.
• Check to make sure power is on by opening a
drawer to see if interior light turns on.
• The interior fan runs all the time except when a
drawer is open.
See the Owner's Manual for further explanation of
the fan.
STEP 5 SLIDE PRODUCT INTO
THE CUTOUT
CAUTION:
drawer panels with your knees. Do not push or lift
the unit by the drawer handles. Damage may occur!
ATTENTION :
panneaux de tiroir avec vos genoux. Ne poussez
jamais votre appareil ou ne le soulevez jamais par
les poignées de tiroir. Vous pouvez l'endommager.
• Open one of the drawers and gently push the unit
back into the opening with your hands against the
sides. Be careful not to entangle power cord.
• Check again to be sure the unit is level. Adjust the
leveling legs until the unit is resting firmly against
the bottom of the counter to prevent rocking or
movement during operation.
• If alignment with adjacent cabinetry is an issue,
use a shim to secure the unit against the underside
of the countertop.
Pub. No. 31-51545-1
Part No. 197D5893P003
02-04 JR
Printed in Slovenia
Installation Instructions
Do not push against the
Ne poussez jamais les
NOTE: While performing installations described in this book,
safety glasses or goggles should be worn.
For Monogram ® local service in your area, call
1.800.444.1845.
NOTE: Product improvement is a continuing endeavor
at General Electric. Therefore, materials, appearance
and specifications are subject to change without notice.
STEP 6 SET TEMPERATURE
CONTROLS
• The temperature controls are preset. Refer to
the Owner's Manual for more information. Allow
12–24 hours for the temperature to stabilize.
NOTE: The Double-Drawer Refrigerator operates
very quietly. You may not notice the unit running,
and when first installed, the fans and motor may not
come on immediately – this is normal. If the display
is lit and the light is working, the unit is operating.