Related Manuals for Monogram ZIDS240WSS
Summary of Contents for Monogram ZIDS240WSS
- Page 1 Design Guide with Installation Instructions Double-Drawer Built-In Refrigerator ZIDI240 ZIDS240 monogram.com...
- Page 2 Installation requires basic mechanical qualifié. skills. Proper installation is the responsibility of the installer. Product failure due to improper installation For Monogram local service in your area, call is not covered under the GE Appliance Warranty. 1.800.444.1845 For Monogram service in Canada, call 1.800.561.3344...
-
Page 3: Table Of Contents
Important Information CONTENTS Design Guide (for ZIDI240) Important Information Step 3, Level ..........7 The Installation Space ......5 Tools Required ..........3 Step 4, Connect Power ......8 Product Clearances........5 Parts Required..........3 Step 5, Slide Product into Cutout ..8 Side-by-Side Installations ......5 Caring for Your Stainless Steel ....3 Step 6, Set Temperature Controls ..8 Installation Instructions Design Guide (for ZIDS240) -
Page 4: Design Guide (For Zids240)
Design Guide FOR MODEL ZIDS240 WITH STAINLESS STEEL DRAWERS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are When installed Countertop designed to be built-in only. They cannot be used in a corner: free-standing. Double-Drawer 22" min. Clearance for Door Opening 2-1/2"... -
Page 5: Design Guide (For Zidi240)
Design Guide FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES THE INSTALLATION SPACE PRODUCT CLEARANCES IMPORTANT: Double-Drawer Refrigerators are When installed Countertop designed to be built-in only. They cannot be used in a corner: free-standing. Double-Drawer 23-1/8" min. Clearance for Door Opening 2-1/2"... -
Page 6: Installation Instructions
Installation Instructions STEP 1 REMOVE PACKAGING STEP 2 INSTALL CUSTOM 3/4" DRAWER PANELS AND • Remove corner blocks and foam drawer stops. HANDLES (CONT.) • Remove all packing material, tape and protective (ZIDI240 model only) plastic coverings. CAUTION: Install custom drawer panels and handles: Small objects are a choke •... -
Page 7: Step 3 Level
Installation Instructions STEP 3 LEVEL STEP 2 INSTALL CUSTOM 3/4" DRAWER PANELS AND Use an adjustable wrench to turn and raise or lower the HANDLES leveling legs. (CONT.) • Measure floor to countertop height inside the opening. (ZIDI240 model only) Adjust leveling legs until the product is approximately 1/8"... -
Page 8: Step 4 Connect Power
NOTE: While performing installations described in this book, safety glasses or goggles should be worn. For Monogram ® local service in your area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General Electric.