Step 3 Level - Monogram ZIDI240 Design And Installation Manual

STEP 2 INSTALL CUSTOM 3/4"
DRAWER PANELS AND
HANDLES
(ZIDI240 model only)
• Reinstall the side trims using the trim screws
removed earlier.
• Place the brushed decorative covers over the side
trim to hide the screw heads. Ensure side trim is
aligned top to bottom and front to back. Snap into
place.
NOTE: For shipping purposes the brushed decorative
cover will be secured to the front of the unit.
Installation Instructions
(CONT.)

STEP 3 LEVEL

Use an adjustable wrench to turn and raise or lower
the leveling legs.
• Measure floor to countertop height inside the
opening. Adjust leveling legs until the product is
approximately 1/8" less than countertop height.
INSTALLATION TIP:
Measure floor to underside of countertop inside
the opening.
• If the room floor is higher than the floor inside
the opening, adjust the rear leveling legs to
approximately 1/8" less than the opening height.
Screw front leveling legs all the way in to shorten
the height at the front. This will allow you to slightly
tip the unit into the opening. Once the unit is in
the correct position, the front legs can be adjusted
to level the product.
7
Turn Right to Lower
Turn Left to Raise