Design Guide (For Zidi240); The Installation Space; Product Clearances; Side-By-Side Installations - Monogram ZIDI240 Design And Installation Manual

FOR MODEL ZIDI240 WITH CUSTOM DRAWER PANELS AND HANDLES

THE INSTALLATION SPACE

IMPORTANT: Double-Drawer Refrigerators are
designed to be built-in only. They cannot be used
free-standing.
Locate
Outlet
8-1/2"
10-1/2"
9"
9" Max.
34-1/2"-35"
Max.
1-1/2"
1-1/2"
23-3/4" Min.
NOTE: Handles
not supplied.*
*Custom handle clearances may vary depending on the standoff of the
custom handles.
The cutout depth should be 24"
The cutout dimensions shown allow for full drawer
extension.
NOTE: The drawers should be flush with the
surrounding cabinets.
Additional Specifications
• A 120 volt 60Hz., 15 or 20 amp power supply is
required. An individual properly grounded branch
circuit or circuit breaker is recommended. Install
a properly grounded 3-prong electrical receptacle
recessed into the back wall as shown. Electrical must be
located on rear wall as shown. NOTE: GFCI (ground
fault circuit interrupter) is not recommended.
SIDE-BY-SIDE INSTALLATIONS –
Custom Panel Models Only
For a complete refreshment center, install a Double-Drawer
Refrigerator beside a Beverage Center or Wine Chiller/
Wine Reserve.
• A side-by-side installation requires at least a 47-1/2" wide
opening. No trim kits required.
• Products must operate from separate, properly grounded
receptacles.
Design Guide
24"
34-1/2"
24-7/8"
23-3/4"

PRODUCT CLEARANCES

When installed
in a corner:
Allow 2-1⁄ 2 " min. clearance between Double-Drawer and
adjacent cabinet, wall or other appliances. Allow 23-1⁄ 8 "
min. clearance from the front for drawer opening.
NOTE: Custom handle clearances may vary depending
on the standoff of the custom handles.
• Test the drawer openings. Carefully open and close
the drawers. The drawers should not rub or catch on
adjacent cabinetry. Notify the installer if the drawers
make contact with cabinetry. NOTE: When installing
custom panels and handles, use above clearances as a
general guide but adjust according to the installation.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for
air circulation and proper access to the drawers.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 90°F (32°C).
• These products are not designed to be stacked one
over the other.
Black or Stainless Steel Toekick Options
• These products are shipped with two toekicks,
a stainless steel and a black toekick. For shipping
purposes, one of the toekicks will be secured to the
back of the unit and the second will be installed,
in place, on the unit. Keep the unused toekick,
and other unused or removed parts, for future use.
34-1/2"-35"
*NOTE: Additional clearances
may be required.
5
Countertop
Double-Drawer
23-1/8" min.
Clearance for Door
Opening 2-1/2" min.
Locate
Outlet
10-1/2" 10-1/2"
14" 24"
9" 9"
15"
1-1/2"
47-1/2" Min.