Installation Instructions; Step 1 Remove Packaging; Step 2 Install Custom 3/4; Drawer Panels And Handles - Monogram ZIDI240 Design And Installation Manual

STEP 1 REMOVE PACKAGING

• Remove corner blocks and foam drawer stops.
• Remove all packing material, tape and protective
plastic coverings.
CAUTION:
Small objects are a choke
hazard for children. Remove and discard any parts
not used.
ATTENTION :
peuvent étrangler les enfants. Il faut jeter toutes
les piéces qui ne sont pas utilisées.

STEP 2 INSTALL CUSTOM 3/4"

DRAWER PANELS AND
HANDLES
3/4" Overlay Panel Dimensions
Model ZIDI240 requires field-
installed overlay drawer panels.
• The overlay panels must be
secured to 1/4" thick backer
panels that slide into the trims.
A .10" thick spacer panel must
be placed between the overlay
and backer panels.
• Custom handles of your choice,
supplied by your cabinet maker,
must be installed on these overlay panels. Countersink
all screws into the backer panels. Screws cannot
protrude from the backer panels.
IMPORTANT NOTE: Maximum total weight for
custom drawer panels are 25 pounds (12-1/2 pounds
maximum each drawer).
A
3/4" Overlay Panel Dimensions (in inches)
12-1/2 lbs. max.
B
1/4" Backer
0.10" Spacer
*
3/4" Overlay
12-1/2 lbs. max.
B
*Maintain a 1/4" min. gap between
top and bottom drawer panels.
Assemble overlay panels with
glue and screws.
• Center spacer panel on the
backer panel, left to right
and top to bottom. Secure
the panels with glue.
• Center the spacer/backer
panel on the overlay panel. Secure with glue and
screws. Countersink all screws into the backer panel.

Installation Instructions

Les petits objets

(ZIDI240 model only)

Overlay
Panel
Drawer
1/4"
.10 Inch
Backer
Spacer
Panel
A (Width) B (Height)
23-3/16" 14-11/16"
22-1/2" 14-3/16"
23-5/8" 15-1/16"
Overlay Panel
Spacer Panel
Backer Panel
STEP 2 INSTALL CUSTOM 3/4"
DRAWER PANELS AND
HANDLES
(ZIDI240 model only)
Install custom drawer panels and handles:
• Open drawers.
• Remove 2 screws holding each trim; lift trims off.
Retain screws.
• Custom handles of your choice, supplied by your
cabinet maker, must be installed onto the overlay
panels before they are slid into the trims.
Countersink all screws into the backer panels.
Screws cannot protrude from the backer panels.
Screws Must
Be Countersunk
Drawer Panel
• Slide overlay panels into the trims.
6
(CONT.)
Into Panel
Handle
Custom