Adjusting The Front Speaker Output Balance; Using The Sleep Timer; Changing The Display Brightness; Recording A Source - JVC RX-9000VBK Instructions Manual

Adjusting the Front Speaker Output
Balance
If the sounds you hear from the front right and left speakers are
unequal, you can adjust the speaker output balance in the main
room.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Press BALANCE/SURROUND
ADJUST repeatedly until "L/R
BALANCE" appears on the
display.
The display changes to show the current setting.
2. Turn MULTI JOG to adjust the
balance.
• Turning it clockwise decreases the left
channel output.
• Turning it counterclockwise decreases the
right channel output.
Note:
This function is applied only to the main room sources.

Using the Sleep Timer

Using the Sleep Timer, you can fall asleep to music and know the
receiver (or the main room source playback) will turn off by itself
rather than play all night.
From the remote control ONLY:
Press SLEEP repeatedly.
The SLEEP indicator lights up on the display, and the
shut-off time changes as follows (in minutes):
10 20 30 40
00 (Canceled)
When the shut-off time comes
The receiver turns off (into standby mode) automatically.
• If the sub-room source is still played (the SUB ROOM ON/OFF lamp on
the front panel is lit) when the shut-off time comes, the receiver will not
turn off, but only the main room sound will shut off.
To check or change the time remaining until the shut-off time
Press SLEEP once.
The remaining time until the shut-off time appears in minutes.
• To change the shut-off time, press SLEEP repeatedly.
To cancel the Sleep Timer
Press SLEEP repeatedly until "SLEEP 00min." appears on the
display. (The SLEEP indicator goes off.)
• Turning off the power also cancels the Sleep Timer.
BALANCE/SURROUND
ADJUST
MULTI JOG
SLEEP
50 60 70 80 90

Changing the Display Brightness

You can dim the display.
On the front panel ONLY:
Press DIMMER.
• Each time you press the button, the display
dims and brightens alternately.
Note:
Even though you have made the display dimmer, it brightens for a
while when you operate the receiver.

Recording a Source

For analog-to-analog recording
You can record any analog source through the receiver to —
• the cassette deck (or MD recorder) connected to the TAPE/MD
jacks,
• the VCR connected to the VCR 1 jacks, and
• the CD recorder (or VCR) connected to the CDR/VCR2 jacks
— at the same time.
For digital-to-digital recording
You can record the currently selected digital input through the
receiver to a digital recording device connected to the DIGITAL
OUT terminal.
• Digital-to-digital recording is only possible when the digital signal
format of the playback source is linear PCM. For recording the
playback source of other digital signal formats, use analog-to-
analog recording method.
Notes:
• Analog-to-digital and digital-to-analog recordings are not possible.
• The output volume level, bass boost (see page 18), SEA modes
(see page 31), and DSP modes (see page 32) cannot affect the
recording.
• The test tone signal (see pages 35 and 37) does not come out
through the DIGITAL OUT terminal.
IMPORTANT:
• While recording, do not turn off the receiver or main room source;
otherwise, recording will stop.
• If the same source is selected both for the main room and the sub-
room, operating the sub-room source will affect the recording.
DIMMER
19