Connecting Audio/Video Components; Analog Connections - JVC RX-8040B Instructions Manual

Connecting Audio/Video Components

When connecting individual components, refer also to the manuals
supplied with them.

Analog connections

If your audio components have digital audio output terminal,
connecting them using the digital cords explained in "Digital
connections" (see page 14).
Audio component connections
Use the cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
If your audio components have a COMPULINK jack
See also page 51 for detailed information about the connection
and the COMPULINK remote control system.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
Turntable
Turntable
If a ground cable is
provided for your turntable,
connect the cable to the
screw marked (H) on the
rear panel.
To audio output
Note:
This connection is for the turntable with an MM (moving-magnet) type
cartridge.
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil) type must be connected to this receiver through a
commercial head amplifier or step-up transformer. Direct connection
may result in insufficient volume.
10
Right / Left
PHONO
IN
R
L
CD player
CD player
To audio
output
CD recorder
CD recorder
To audio input
Right / Left
R
OUT
(REC)
L
CDR
IN
(PLAY)
Right / Left
R
CD IN
L
To audio output
L
R