Emergency - HYT TC-780 User Manual

Note: To assure scan speed, adjacent channel frequency should not be above 30MHz.

Emergency

Activate Emergency
The Emergency key can be programmed by your dealer. You may activate Emergency by
the following methods:
1. Press the Emergency key (long or short) to activate the Emergency Mode.
2. Activate Emergency while in Lone worker mode. See Lone Worker for details.
3. Activate Emergency while in Man Down mode. See Man Down for details.
Exit Emergency
The radio shall return to the original channel after it exits the Emergency Mode. You may
exit Emergency by the following methods:
1. Press the Emergency key (long or short) again to exit the Emergency Mode.
2. Receive the Exit Emergency code while in Emergency Mode.
3. The radio shall automatically exit Emergency Mode after the programmed Limit
Emergency Cycle expires.
4. Place the radio vertically to exit Emergency while in Man Down mode.
5. Turn the radio off.
Emergency Mode
After the radio enters the Emergency Mode, it shall switch to the preset Emergency
Channel. The Emergency process is divided into four stages: Transmit ID, Transmit Alarm,
Transmit Surrounding Audio, Forcibly Receive. The number of times the radio cycles
among the stages is programmable by your dealer. Available emergency modes are:
1. No emergency alarm shall be transmitted.
2. Emergency alarm is heard from the local speaker.
3. Emergency alarm shall be heard from the receiving party.
4. Emergency alarm shall be heard from both transmitter and receiver.
5. If the Discreet Emergency is enabled, the radio shall enter the Discreet Emergency
31