Table of Contents
Advertisement
Basic setting
Operating voltage
220-230V
Restore factory settings:
no
Changing the basic settings
Prerequisite: The oven must be switched off.
Example in the picture: changing the audible signal duration
basic setting from medium to short.
Press and hold the
button for approximately 4 seconds until
°
1.
the heading "Basic setting" and the first basic setting "Select
language" appears.
%DVLF VHWWLQJ
6HOHFW ODQJXDJH
(QJOLVK
6WRUH VHF
Turn the rotary selector to select the required basic setting.
2.
%DVLF VHWWLQJ
6LJQDO GXUDWLRQ
PHGLXP
6WRUH VHF
Automatic switch-off
Your oven has an automatic switch-off function. It is activated if
no cooking time is set and the settings have not been changed
for a long time. The point at which this occurs depends on the
temperature or grill setting that has been set.
Switch-off activated
"Automatic switch-off" appears in the display. Operation is
Care and cleaning
With careful care and cleaning your microwave oven will retain
its looks and remain good order. We will explain here how you
should care for and clean your appliance correctly.
ã=
Risk of short circuit!
Never use high-pressure cleaners or steam cleaners to clean
the oven.
ã=
Risk of burns!
Never clean the appliance immediately after switching off. Let
the appliance cool down.
Notes
Slight differences in colour on the front of the appliance are
■
caused by the use of different materials, such as glass,
plastic and metal.
Shadows on the door panel which look like streaks, are
■
caused by reflections made by the oven light.
16
Options
220-230V
230-240V
no
yes
Press the
3.
Change the basic setting by turning the rotary selector.
4.
You can now make further changes to the basic settings by
pressing the
changes as described in points 2 to 4.
Press and hold the
5.
takes about 4 seconds. All changes are saved.
Cancelling
Press the
interrupted. Press any button to clear the text. You can make
new settings.
Note. If a cooking time is set, the oven stops heating once the
cooking time has elapsed. The automatic switch-off function is
not necessary.
Enamel is baked on at very high temperatures. This can
■
cause some slight colour variations. This is normal and does
not affect their function. The edges of thin trays cannot be
completely enamelled. As a result, these edges can be
rough. This will not impair the anti-corrosion protection.
Unpleasant odours, e.g. after fish has been prepared, can be
■
removed very easily. Add a few drops of lemon juice to a cup
of water. Place a spoon into the container as well, to prevent
delayed boiling. Heat the water for 1 to 2 minutes at
maximum microwave power.
Cleaning agents
To ensure that the different surfaces are not damaged by using
the wrong cleaning agent, observe the information in the table.
Do not use
sharp or abrasive cleaning agents,
■
metal or glass scrapers to clean the glass in the appliance
■
door,
metal or glass scrapers to clean the door seal,
■
Explanation
Adjusting the operating voltage
Reverse all changes and restore basic
settings.
button to move to the next line.
X
Y
button to change line and then making the
%DVLF VHWWLQJ
6LJQDO GXUDWLRQ
VKRUW
6WRUH VHF
button until the clock appears. This
°
button. The changes are not applied.
%
Advertisement
Table of Contents
