Cleaning The Glass Panels; Malfunction Table - Bosch HBC86K7.3N Instruction Manual

Table of Contents

Advertisement

Use both hands to slide it back into the two catches. (Fig. B).
2.
$
Pull the clip forwards and push the glass cover upwards. Let
3.
go of the clip. (Fig. C)
&
Remove the tea towel from the oven.
ã=
Risk of serious damage to health.!
Never operate the appliance without the microwave glass
cover. Microwave energy may escape.

Cleaning the glass panels

The glass panels can be removed from the oven door for
cleaning.
ã=
Risk of burns!
Do not remove the panels immediately after switching the
appliance off. The oven must be cold.
Removal
Open the oven door.
1.
Undo the two screws on the door using a flat-bladed
2.
screwdriver (blade width 8-11 mm). Hold the door panel
firmly while doing this. (Fig. A).
Position the door at an angle and pull out the panel upwards
3.
by the door handle. (Fig. B).
$

Malfunction table

Malfunctions often have simple explanations. Please refer to the
malfunction table before calling the after-sales service.
If a meal does not turn out exactly as you wanted, refer to the
Tested for you in our cooking studio section, where you will
find plenty of cooking tips and tricks.
18
%
%
Close the door.
4.
Notes
Clean the glass panel with glass cleaner and a soft cloth.
Do not use any sharp or abrasive agents. The glass scraper
is not suitable.
Refitting
Insert the door panel into the guide with both hands. (Fig. A).
1.
Push the door panel downwards, lift it slightly and hook it in
2.
at the top. (Fig. B).
$
Make sure that the door panel is sitting flush with the control
panel.
Fully open the door, while holding the panels firmly with one
3.
hand. (Fig. C).
Push the door downwards again and tighten the screws
4.
hand-tight using a flat-bladed screwdriver (blade width 8-
11 mm), close the door. (Fig. D).
&
Caution!
You must not use the oven again until the panels have been
properly refitted.
ã=
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be carried
out by one of our trained after-sales engineers.
%
'

Advertisement

Table of Contents
loading

Table of Contents