Configuring The Procurve Wireless Edge Services Zl Modules; J9052A); Configuring An Ip Address For The Module - HP ProCurve 5400zl Installation And Getting Started Manual

Configuring the ProCurve Wireless Edge
Services zl Modules (J9051A, J9052A)
Before beginning the configuration, backup the current configuration of the
switch.
The zl switch software must be updated to a version (K.12.40) that supports
the module. Visit
verify module support, refer to the version's Release Notes.
The ProCurve Wireless Edge Services zl Module (J9051A) and the ProCurve
Redundant Wireless Services zl Module (J9052A) must be running software
version WT.01.xx or later.
N o t e
The term 'module' is used in this section to refer to both the ProCurve Wireless
Edge Services zl Module (J9051A) and the ProCurve Redundant Wireless
Services zl Module (J9052A).
There are four module configuration tasks required:
■
■
■
■

Configuring an IP Address for the Module

By default, the module uses DHCP to get an IP address. The zl switch CLI has
a command context, the wireless-services context, for configuring and man-
aging a module.
N o t e
'ProCurve' is used here as a generic prompt for all zl switches.
■
■
Configuring the ProCurve Wireless Edge Services zl Modules (J9051A, J9052A)
www.procurve.com/software
configuring an IP address for the module
configuring VLANs on the zl switch
determining a module configuration backup process
configuring wireless LAN services
To identify the slot in the zl switch where the module is installed, enter
the following command:
ProCurve# show modules
To show the module's IP address, enter the following command to access
the module's wireless-services CLI context for the module:
ProCurve# wireless-services <slot-id>
where <slot-id> is the slot in the zl switch where the module is installed.
Getting Started With Switch Configuration
to obtain a supported version; to
3-7