Download Print this page

Advertisement

Getting Started With Switch Configuration
Configuring the ProCurve Wireless Edge Services zl Modules (J9051A, J9052A)
The following example enters the wireless-services context of a module
installed in Slot B of a zl switch and then displays the IP address assigned by
DHCP to the module:
If no DHCP service is available or if the administrator wishes to manually set
the Wireless Edge Services zl Module IP Address, it can be specified through
the CLI. From the wireless-services context, enter the config context and use
the interface vlan1 command to configure the vlan1 interface. Use the following
command to set the IP address:
ProCurve(wireless-services-<slot-id>)(config-if)# ip address <IP>
In the following example, the CLI commands set the module's IP address to
10.245.22.14 with a 21-bit subnet mask.
If necessary, use the following command from the wireless-services and config
contexts to set or change the default gateway:
ProCurve(wireless-services-B)(config)#ip default-gateway <ip-addr>
3-8
To display the module's IP address, enter:
ProCurve (wireless-services-id)# show ip interfaces
ProCurve# wireless-services b
ProCurve(wireless-services-B)#show ip interface
Interface
IP-Address/Mask
vlan1
10.35.12.24(DHCP) up
ProCurve(wireless-services-B)#
where <slot-id> is the slot in the zl switch where the module is installed.
<IP> is the IP address in CIDR notation (/mask bit number), or
dhcp which will use DHCP to obtain an IP address.
ProCurve(wireless-services-B)#configure
ProCurve(wireless-services-B)(config)#interface vlan1
ProCurve(wireless-services-B)(config-if)#ip address 10.245.22.14/21
ProCurve(wireless-services-B)(config-if)#show ip interface
Interface
IP-Address/Mask
vlan1
10.245.22.14/21
ProCurve(wireless-services-B)(config-if)#
where <ip-addr> is the numeric IP address of the default gateway, for
example 10.1.2.1.
Status
Protocol
up
Status
Protocol
up
up

Advertisement

Troubleshooting

   Related Manuals for HP ProCurve 5400zl

Comments to this Manuals

Symbols: 0
Latest comments: