Application Setup; Application Setup Operation; Camera Setting; Setting The Camera Input - Alpine iLX-007 Owner's Manual

Application Setup

Application Setup Operation

To display the Application Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Setup operation has been
released. Engaging the parking brake can reactivate the
Application Setup Menu, as long as the car's ignition has not
been turned off. It is not necessary to repeat the above procedure
(1 through 2) of "To display the Application Setup Menu screen".
Each time the ignition is turned OFF, perform the procedure of "To
display the Application Setup Menu screen".
The following steps 1 to 5 are common operations to each
"Setting item" of Application Setup. Refer to each section for
details.
1
Touch [ ] on the Home screen.
The Setup main screen is displayed.
2
Touch [Application].
The Application Setup screen appears.
3
Select the desired item.
If " " appears, there is another hierarchy level. Touch the
desired item.
If " " does not appear, proceed to step 4.
Setting items: Camera / Auxiliary (AUX) / Apple CarPlay
4
Touch [ ] or [ ] etc., to change its setting.
5
Touch [ ] to return to the main application screen.
Touch [ ] to return to the previous screen.
• Immediately after changing the Application Setup (while the system
is writing data automatically) do not turn the ignition key to OFF.
Otherwise, the settings may not be changed.

Camera Setting

[Camera] is selected on the Application setup menu in step 3. Refer to
"Application Setup Operation" (page 22).

Setting the Camera Input

With an optional camera connected, its video is output to the monitor.
When the camera is connected, set this item.
Setting item: Position
Setting contents: Off (Initial setting) / Rear / Other
Rear: Rear camera
Other: Side camera, Room camera, etc.
After selecting "Rear" or "Other" in the "Position"
setting, touch of [Position], the following additional
items can be adjusted.

Setting the Camera Signal Input

When the camera is connected, the video input signal type can be
selected.
Further setting item: Camera Signal
Setting contents: NTSC (Initial setting) / PAL
NTSC/PAL: Choose the video input signal type manually.

Adjusting the Rear Camera Guide

If you select "Rear," you can adjust the camera guide position.
Setting item: Guide Adjustment
1
Touch [Guide Adjustment].
The camera guide adjustment screen is displayed.
2
Touch the guide you intend to adjust.
Guide line can also be selected by touching [
Display example for rear camera mode
3
Touch [ ], [ ], [
of the guide.
• Touching [Clear] clears adjustments and returns to the setting
before guide line alteration.
4
After the adjustment is completed, touch [Set].
] [
] or [ ] to adjust the position
22
].
-EN