Table of Contents
Advertisement
01GB00ICS-X7.book Page 29 Friday, October 12, 2012 9:24 PM
Security Code Setting
[Security Code] is selected on the General setup menu in step 3. Refer
to "General Setup Operation" (page 25).
Setting Security Code
You can set the system to be unusable without entering a password.
When you turn this setting to "On" and set a password, password input
is required when the system is connected to a battery and turned on for
the first time.
Setting item: Security Code
Setting contents: Off (Initial setting) / On
Setting the password
1
Touch [
] or [
] of "Security Code" to set to "On."
2
After the confirmation message appears, touch
[OK].
The password setting screen is displayed.
3
Enter a password, then touch [Enter].
• Enter the 6-digit number.
• Input numbers are displayed as "*."
4
Enter the same password again, then touch [Enter].
The password is set and the system returns to the previous
screen.
• If you forget a registered password, you can not use this unit. In this
case, service will be required.
Clearing the password
1
Touch [
] or [
] of "Security Code" to set to "Off."
The password setting screen is displayed.
2
Enter the password you have set, then touch
[Enter].
The password is cleared and the system returns to the
previous screen.
• Input numbers are displayed as "*."
01GB05ICS-X7.fm
Application Setup
Application Setup Operation
The parking brake must be engaged to access the Application
mode screen. Attempting to access this screen while driving will
display the warning-Unable to operate while driving.
The following steps 1 to 5 are common operations to each
"Setting item" of Application Setup. Refer to each section for
details.
1
Touch [Setup] on the Home screen.
The Setup main screen is displayed.
2
Touch [Application Setup].
The Application Setup screen appears.
3
Select the desired item.
If "
" appears, there is next hierarchy. Touch the desired
item.
If "
" does not appear, proceed to step 4.
Setting items: Camera / AUX / Phone / MirrorLink
4
Touch [
] or [
] etc., to change its setting.
5
Touch [ ] to return to the main application screen.
Touch [ ] to return to the previous screen.
• Immediately after changing the Application Setup (while the system
is writing data automatically) do not turn the ignition key to OFF.
Otherwise, the settings may not be changed.
ALPINE ICS-X7 68-21057Z38-A (EN)
29
-EN
Advertisement
Table of Contents
