Basic Operation; Detaching The Front Panel; Attaching The Front Panel; Initial System Start-Up - Alpine TDM-7582 Owner's Manual

Basic Operation

A.S.U.

Detaching the Front Panel

1
Press the POWER button to turn off the power.
2
Press the (Release) button until the front
panel pops out.
3
Grasp the left side of the front panel and pull it
out.
NOTES
• The front panel may become hot (especially the connector
terminals). This is not a malfunction.
• To protect the front panel, place it in the supplied carrying
case.

Attaching the Front Panel

1
First, insert the right side of the front panel into
the main unit. Align the 2 small holes on the front
panel with the 2 projections on the main unit.
2
Push the left side of the front panel until it locks
firmly into the main unit.
NOTE
Before attaching the front panel, make sure that there is no
dirt or dust on the connector terminals and no foreign object
between the front panel and the main unit.
4
-EN
2
POWER
1
2
1 1
MODE/LOUD
c
ZERO

Initial System Start-Up

1
Immediately after installing or applying power to
the unit, it should be initialized. To do this, first,
remove the detachable front panel. Behind the
front panel, to the right of the connector, there is
a small hole. Using a pencil or other pointed
object, press the red Reset switch mounted
behind this hole to complete the initialization
procedure.

Automatic Setup (A.S.U.)

This convenient feature sets up the unit
automatically after installation.
1
Press the POWER button to turn on the unit.
NOTE
When Power is turned on for the very first time, the
A.S.U. (Automatic Set-Up) function will be initiated
automatically. See A.S.U. description below.
CLOCK
HOUR
MIN
Reset switch