Alpine iLX-007 Owner's Manual page 30

Car receiver
Table of Contents

Advertisement

Video/Audio (R,L) Input Connector (AUX INPUT)
Input the AUX Video/Audio (R,L).
• When you use this connector, an optional AV/RCA interface cable
should be used.
Usable AV/RCA interface cable (4-pole mini AV plug
to 3-RCA)
Wiring convention of this system is as follows:
Audio L (White)
Audio R (Red)
Ground
Video (Yellow)
Yellow
Red
White
• Configuration commercially available 4-pole mini AV plugs is not
standardized.
Remote Control Output Lead (Brown)
Connect this lead to the remote control input lead. This lead
outputs the controlling signals from the remote control.
CAMERA Input Connector
Radio Antenna Receptacle
RCA Extension Cable (sold separately)
USB Connector
To iPhone 5 or later.
Power Supply Connector
Front Output RCA Connectors
It can be used as Front Output RCA Connectors. RED is
right and WHITE is left.
Rear Output RCA Connectors
It can be used as Rear Output RCA Connectors. RED is
right and WHITE is left.
Subwoofer RCA Connectors
RED is right and WHITE is left.
Steering Remote Control Interface Connector
To steering remote control interface box.
For details about connections, consult your nearest Alpine
dealer.
AUX/CAMERA/REMOTE OUT Connector
MIC Input Connector
To Microphone (Included).
Fuse Holder (10A)
Remote Turn-On Lead (Blue/White)
Connect this lead to the remote turn-on lead of your
amplifier or signal processor.
Reverse Lead (Orange/White)
Connect to the plus side of the car's reverse lamp. This
lamp illuminates when the transmission is shifted into
reverse (R).
With this lead properly wired, the video picture
automatically switches to the rear camera whenever the car
is put into reverse (R).
Parking Brake Lead (Yellow/Blue)
Connect this lead to the power supply side of the parking
brake switch to transmit the parking brake status signals to
the iLX-007.
• This lead should be used only for controlling the vehicle's power
Video input
terminal
Audio input
terminal
(R,L)
Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna,
if applicable.
antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle's fuse
box or another unused power source which provides (+)
12V only when the ignition is turned on or in the accessory
position.
Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle.
Make sure the connection is made to bare metal and is
securely fastened using the sheet metal screw provided.
Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle's
battery.
Left Rear (+) Speaker Output Lead (Green)
Left Rear (–) Speaker Output Lead (Green/Black)
Left Front (+) Speaker Output Lead (White)
Left Front (–) Speaker Output Lead (White/Black)
Right Front (–) Speaker Output Lead (Gray/Black)
Right Front (+) Speaker Output Lead (Gray)
Right Rear (–) Speaker Output Lead (Violet/Black)
Right Rear (+) Speaker Output Lead (Violet)
30
-EN

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents