Table of Contents
Advertisement
Initializing the System
You can initialize all data, to restore the factory settings. Remove the
USB Flash memory, from the system before operation
Setting item: Clear All Settings
1
Touch [RESET] of "Clear All Settings".
2
After the confirmation message appears, touch
[OK].
The system starts initialization.
• Do not turn on/off the power, change the ignition key position or
remove the screen panel until system restart is completed.
Demonstration Setup
[Demo mode] is selected on the General setup menu in step 3. Refer to
"General Setup Operation" (page 20).
Canceling the Demonstration
This unit has a Demonstration feature for the display. To start demo
mode, set Demo mode to ON.
Setting item: Demo mode
Setting contents: OFF (Initial setting) / ON
• If you perform an operation during the Demo mode, the
demonstration is temporarily stopped.
Application Setup
Application Setup Operation
To display the Application Setup Menu screen:
Your vehicle must be parked with the ignition key in the ACC or
ON position. To do this, follow the procedures below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Release the parking brake. (For safety, release the
parking brake while depressing the foot brake pedal).
3 Engage the parking brake again.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Setup operation has been
released. Engaging the parking brake can reactivate the
Application Setup Menu, as long as the car's ignition has not
been turned off. It is not necessary to repeat the above procedure
(1 through 3) of "To display the Application Setup Menu screen".
Each time the ignition is turned OFF, perform the procedure of "To
display the Application Setup Menu screen".
The following steps 1 to 5 are common operations to each
"Setting item" of Application Setup. Refer to each section for
details.
1
Touch [
] on the Home screen.
The Setup main screen is displayed.
2
Touch [Application].
The Application Setup screen appears.
3
Select the desired item.
If " " appears, there is another hierarchy level. Touch the
desired item.
If " " does not appear, proceed to step 4.
Setting items: Camera / Auxiliary (AUX) / Factory Audio / Apple
CarPlay / External Accessory Ctrl
4
Touch [
] or [
] etc., to change its setting.
5
Touch [ ] to return to the main application screen.
Touch [ ] to return to the previous screen.
• Immediately after changing the Application Setup (while the system
is writing data automatically) do not turn the ignition key to OFF.
Otherwise, the settings may not be changed.
Camera Setting
[Camera] is selected on the Application setup menu in step 3. Refer to
"Application Setup Operation" (page 22).
Setting the Camera Input
With an optional camera connected, its video is output to the monitor.
When the camera is connected, set this item.
Setting item: Position
Setting contents: Off (Initial setting) / Front / Side / Rear
Front:
Front camera
Side:
Side camera
Rear:
Rear camera
After selecting "Rear", "Front" or "Side" in the
"Position" setting, touch [Position], the following
additional items can be adjusted.
Setting the Camera Signal Input
When the camera is connected, the video input signal type can be
selected.
Further setting item: Camera Signal
Setting contents: NTSC (Initial setting) / PAL
NTSC/PAL:
Choose the video input signal type manually.
22
-EN
Advertisement
Table of Contents
