Table of Contents
Advertisement
Serial Trigger Character (Delimited)
Serial Trigger Character (Delimited)
Usage:
Allows the user to define the trigger character and delimiters that start
and stop the read cycle.
Definition:
A serial trigger is considered an online host command and requires the
same command format as all host commands. It must be entered within
angle bracket delimiters
define individual start and stop characters.
Serial Cmd:
<K201,serial trigger
Default:
^] (<GS>)
Options:
Any single ASCII character, including control characters, except NUL (00 in
hex), an existing host command character, or an on-line protocol character.
Control characters entered on the command line are displayed in the menu
as mnemonic characters.
Note: Serial Data or Serial Data and Edge triggering mode must be
enabled for Serial Trigger Character to take effect.
4-10
< >
or, in the case of non-delimited triggers, it must
character>
MS-2 CCD Reader User's Manual
Advertisement
Table of Contents
Need help?
Do you have a question about the MS-2 and is the answer not in the manual?
Questions and answers