Wireless Door Lock Control System Inspection - Lexus 2005 IS300 User Manual

BE-136
2005 LEXUS IS300 (RM1140U)
BODY ELECTRICAL - WIRELESS DOOR LOCK CONTROL SYSTEM
INSPECTION
1. INSPECT WIRELESS DOOR LOCK TRANSMITTER
OPERATION
HINT:
Refer to "Wireless door lock control transmitter battery replace-
ment" on page
(a) Using a screwdriver, remove the screw and cover.
(b) Remove the battery (lithium battery).
(c) Install a new or normal battery (lithium battery).
HINT:
When a new or normal battery can not be obtained, connect 2
new 1.5 V batteries in series, connect the battery (+) to the bat-
tery receptacle side terminal and battery (-) to the bottom termi-
nal, then apply 3 V voltage to the transmitter.
(d) In the location where is approx. 1 M away from driver's
outside handle in the right direction, face the key plate of
the transmitter to the vehicle, and check the transmitter
I04149
operation when pressing transmission switch on the side
of the transmitter body.
Standard:
F
Remote control of vehicle door lock can be operated.
F
LED lights up more than once.
HINT:
F
The minimum operation distance differs according to op-
erator, the way of holding the transmitter, and location.
F
As weak wave is used, operation distance might be short-
ened when noise is detected in strong wave or used fre-
quency.
(e) Install the battery (lithium battery).
(f) Install a cover so that O-ring is not distorted or slipped off.
(g) Using a screwdriver, tighten the screw.
BE-140 .
Author :
BE1WW-02
Date :
2137